服务热线:
400-879-1999
栏目导航
联系我们
服务热线
400-879-1999
电话:400-879-1999
地址:山东省莱州市206国道与308省道交叉口东南50米
当前位置:首页 > 搅拌车资讯 > 常见问题自动上料搅拌车操作要点有哪些?
自动上料搅拌车操作要点有哪些?
来源:http://www.cnzkjf.cn发布日期:2020-07-30   浏览量:0
 
1、起动混凝土自动上料搅拌车之前,应把搅拌筒操作手柄放在“停止”位置。
 
1. Before starting the automatic concrete loading mixer, the mixing cylinder operation handle should be placed in the "stop" position.
 
2、自动上料搅拌车起动发动机后,应使搅拌筒在低速下转动10分钟左右,使液压油温升到20℃以上后方可工作。装运搅拌好的混凝土时,搅拌筒转速为2-10转/分,在运输过程中,平坦路面上搅拌筒转速保证在2-3转/分,行驶在侧倾坡度大于50的路面,或左右晃动较大的路面时,应停止搅拌旋转,待路况好转后再恢复搅拌旋转。
 
2. After starting the engine of the automatic feeding mixer, the mixing drum should be rotated at low speed for about 10 minutes to make the temperature of hydraulic oil rise above 20 ℃. When transporting the mixed concrete, the speed of the mixing drum shall be 2-10 rpm. During the transportation, the rotation speed of the mixing drum shall be kept at 2-3 rpm on the flat road surface. When driving on the road surface with a roll gradient greater than 50, or the road with large left-right shaking, the mixing rotation shall be stopped and the mixing rotation shall be resumed after the road conditions are improved.
 
3、自动上料搅拌车在运输混凝土时,要保证滑斗放置牢固,防止因松动造成摆动,在行进中打伤行人或影响其它车辆正常运行。
 
3. When transporting concrete with automatic feeding mixer, it is necessary to ensure that the sliding bucket is placed firmly to prevent swinging due to looseness, which may injure pedestrians or affect the normal operation of other vehicles.
 
4、自动上料搅拌车出料完毕,应立即用随车的软管放水将进料口、出料斗及出料溜槽等部位冲洗干净,排去粘结在车身各处的污物及残留混凝土,再向搅拌筒内注水150-200L的清水,在返回途中要让搅拌筒慢速转动,以清洗内壁,避免残余料渣附在筒壁和搅拌叶上,并在再一次装料前将这些水放掉。
 
4. After discharging, the automatic loading mixer should immediately flush the inlet, discharge hopper, discharge chute and other parts with the hose attached to the vehicle to drain the dirt and residual concrete adhered to the vehicle body, and then inject 150-200l of clear water into the mixing drum. On the way back, the mixing drum should rotate slowly to clean the inner wall and avoid the residual slag adhering to the cylinder wall and mixing blades, And drain the water before loading again.


中科自动上料搅拌车
 
自动上料搅拌车
 
Automatic feeding mixer
 
5、在检查、修理自动上料搅拌车液压传动部分时,应使发动机和液压泵在没有压力的情况下进行。
 
5. When checking and repairing the hydraulic transmission part of the automatic feeding mixer, the engine and hydraulic pump should be operated without pressure.
 
6、自动上料搅拌车运送混凝土塌落度不得低于8cm。从混凝土入罐到排出,气温高时不得超过2小时必须排出,阴雨天气温度低时,不得超过2.5小时。
 
6. The slump of concrete transported by automatic loading mixer shall not be less than 8cm. From the concrete entering into the tank to discharging, it shall not exceed 2 hours when the temperature is high, and it shall not exceed 2.5 hours when the temperature is low in rainy days.
 
7、混凝土自动上料搅拌车车内装有混凝土时,在现场停滞时间不得超过1小时,如超时应立即要求现场负责人给予及时处理。
 
7. When concrete is loaded in the mixer truck for automatic concrete loading, the dead time on site shall not exceed 1 hour. If the truck exceeds the time limit, the person in charge of the site shall be required to deal with it in time.
 
8、自动上料搅拌车水箱的水量要经常保持装满,以备急用,冬季停机后,应将水箱、水泵、水管、搅拌筒内的水放净,并停放在朝阳、不积水的地方,以免冻坏机械。
 
8. The water volume of the water tank of the automatic feeding mixer truck should be always full in case of emergency. After shutdown in winter, the water in the water tank, water pump, water pipe and mixing drum should be drained completely, and the water should be stored in a place where there is no water in the morning sun, so as to avoid freezing damage to the machinery.
 
以上就是小编为大家介绍的关于自动上料搅拌车操作要点,如果想了解关于自动上料搅拌机的相关知识,可以关注公司网站:http://www.jfhntjbj.com
 
The above is about the operation points of the automatic feeding mixer. If you want to know about the automatic charging mixer, you can pay attention to the company's website: http://www.jfhntjbj.com 。

莱州中科聚峰机械有限公司 电话:15053524111 地址:山东省莱州市206国道与308省道交叉口东南50米