In the actual operation of the equipment, the transmission of Zhongke Jufeng automatic loading mixer is a very important part. Therefore, we need to test the quality of oil products in the process of use, so how should we operate?

　　1.将自动上料混合机置于水平地面上，拧紧手刹。

　　1. Place the automatic feeding mixer on the horizontal ground and tighten the handbrake.

　　2.让发动机空转几分钟。

　　2. Allow the engine to idle for a few minutes.

　　3.踩下制动踏板，控制手柄向后退、前进等位置，并在每个位置停留几秒钟，使液力变矩器和所有换档执行机构都充满液压油。，将控制手柄推到停止位置。

　　3. Press the brake pedal, control the handle to the backward, forward and other positions, and stay at each position for a few seconds, so that the hydraulic torque converter and all shift actuators are filled with hydraulic oil. Finally, push the control handle to the stop position.

　　4.从油管中取出自动变速器上的直尺，将清洗干净的所有直尺放入油管中，然后拔出，检查标尺上的油位高度。

　　4. Take out the straight edge on the automatic transmission from the oil pipe, put all the cleaned straight edge into the oil pipe, then pull out and check the oil level on the scale.

　　在自动上料搅拌车的变速器进行传动检测或故障诊断，对传动油位和油质进行检测。把齿轮选择处理在P的位置,发动机将闲置少几分钟运行,石油达到正常的工作温度,车必须停在路的水平,以确保微分和传输之间的油位高度是正常的和稳定的。

　　Transmission detection or fault diagnosis is carried out in the transmission of the automatic feeding mixer, and transmission oil level and oil quality are detected. When the gear is selected at the P position, the engine will run idle for at least a few minutes, and the oil will reach the normal working temperature. The vehicle must stop at the road level to ensure that the oil level between differential and transmission is normal and stable.

　　以上是中科聚峰厂家为大家介绍的相关内容，想要了解更多内容，欢迎访问网站：http://www.cnzkjf.cn

　　The above is the relevant content introduced by Zhongke Jufeng factory. To learn more, please visit the website: http://www.cnzkjf.cn