There are a lot of dirt in the automatic charging mixer occasionally, so there will be many accidents in the operation process. Zhongke Jufeng small editor tells you five ways to easily clean the dirt in the automatic charging mixer, go and have a look!

　　应急驱动软管应先准备好，关闭机器，拆卸液压马达上的高压管接头。

　　The emergency drive hose shall be prepared first, the machine shall be shut down, and the high-pressure pipe joint on the hydraulic motor shall be removed.

　　关闭救援车，取下液压马达的高压管，用应急驱动软管与故障车辆的对应接头连接。

　　Close the rescue vehicle, remove the high-pressure pipe of the hydraulic motor, and connect the emergency drive hose with the corresponding joint of the failed vehicle.

　　启动回收车，将操作手柄推排放位置，故障车辆内的混合气排放。

　　Start the recovery vehicle, push the operating handle to the emission position, and exhaust the mixture in the failed vehicle.

　　当紧急驱动完成后，从自动给料混合器上拆下驱动软管，并回到原始状态。

　　When the emergency drive is complete, remove the drive hose from the automatic feed mixer and return to the original state.

　　在拖船和滚道之间放置一个木楔，控制搅拌缸的旋转，关闭发动机，取下液压马达的高压油管，搅拌缸可以自由旋转，控制搅拌缸的旋转。使维修孔处于较低的位置，然后打开维修孔，并将混凝土清理出料缸，当混凝土排出完毕后，返回到原来的状态的自动上料搅拌机。

　　A wooden wedge is placed between the tug and the raceway to control the rotation of the mixing cylinder. The engine is shut down and the high-pressure oil pipe of the hydraulic motor is removed. The mixing cylinder can rotate freely to control the rotation of the mixing cylinder. Make the maintenance hole in a lower position, then open the maintenance hole, and clean the concrete out of the tank. When the concrete is discharged, return to the original state of the automatic feeding mixer.

　　以上是中科聚峰厂家为大家介绍的5种方法，都可以去除土壤残留，不管你现在用哪种方法都要注意问题。

　　The above are five methods introduced by Zhongke Jufeng factory. They can remove soil residues. No matter which method you use now, you should pay attention to safety issues.