强制式混凝土搅拌机的故障的检查方式
1 reason:
拌铲或刮板松脱或翘曲致使和搅拌筒碰撞。
The shovel or scraper is loose or warped, resulting in collision with the mixing drum.
办法:
terms of settlement:
紧固拌铲或刮板的连接螺栓,检修,调整拌铲,刮板和筒壁之间的间隙。
Tighten the connecting bolts of the mixing shovel or scraper, overhaul and adjust the gap between the mixing shovel, scraper and the cylinder wall.
拌铲转动不灵运转声异常
The mixing shovel does not rotate properly, and the running sound is abnormal
2原因:
2 reason:
1、搅拌装置缓冲弹簧失效。
1、 Buffer spring of mixing device fails.
2、拌合料中有大颗粒物料卡住拌铲。
2. There is a large particle material stuck in the mix shovel.
3、加料过多,动力超载。
3. Too much feeding, power overload.
办法:
terms of settlement:
1、更换弹簧。
1. Replace the spring.
2、卡赛的物料。
2. Clear the material of Kasai.
3、按规定进料容量投料。
3. Feed according to the specified feeding capacity.
运转中卸料门漏浆
Slurry leakage from discharge valve during operation
3原因:
3 reasons:
1、卸料门封闭不严密。
1. The discharge door is not closed tightly.
2、卸料门周围残存的粘接物过厚。
2. The remaining adhesive around the discharge door is too thick.
排出方法:
Discharge method:
1、调整卸料底板下方的螺栓,使卸料门封闭严密。
1. Adjust the bolts under the unloading base plate to make the unloading door tightly closed.
2、残存的粘结物料。
2. Remove the remaining bonding material.
上料斗运行不平稳
The feeding hopper runs unevenly
4原因:
4 reasons:
上料轨道翘曲不平,料斗滚轮接触不良。
The feeding track is warped and uneven, and the hopper roller is in poor contact.
排出方法:
Discharge method:
检查调整两条轨道,使轨道平直,轨面平行。
Check and adjust the two tracks so that the track is straight and the rail surface is parallel.
上料斗上升时越过上点而拉坏牵引机构
When the upper hopper rises, it will cross the top to the point and pull out the traction mechanism
5原因:
5 reason:
1、自动限位失灵。
1. Automatic limit failure.
2、自动限位挡板变形而不起作用。
2. The automatic stop plate is deformed and does not work.
办法:
terms of settlement:
1、检修或更换限位装置。
1. Repair or replace the limit device.
2、调整限位挡板。
2. Adjust the stop plate.